Mobile：18928206361
Telephone：0769-82586018
Fax：0769-81668689
E-mail：sales@pxmotorsm.com
The Italy reducer is a power transmission mechanism, which uses a gear speed converter to decelerate the number of turns of the motor (motor) to the desired number of turns and obtain a larger torque mechanism. At present, the reducer is widely used in the transmission of power and motion. In the installation and use of the process, there are some specific matters needing attention to us to observe, what is the main? Here is a small series for you to introduce, there are eight main points, as follows:
1, speed reducer drive joints is necessary in the installation of protective devices, such as a protrusion connector or use gear, sprocket drive, radial loads if the output shaft is larger, should also strengthen the type selection.
2, reducer installation position to ensure that the operation of the staff, including easy access to vernier, breather plug and drain plug and other places. After the installation of the reducer, the inspectors shall check the accuracy of the installation location in sequence, and determine the reliability of each fastener.
3, speed reducer before running, and ready for operation, the ventilation hole plug off the oil pool for ventilation plug, open the oil level plug screw check oil line height, add lubricating oil level plug screw hole more than to overflow, and then plug and screw on the oil level to determine the correct, can start trial operation.
4. The running time of the reducer can not be less than two hours. The standard of normal operation is smooth running, no vibration, no noise, no leakage and no shock. If there is any abnormal situation, it should be eliminated in time.
5, reducer in the installation, we should pay special attention to the central axis of the transmission center, the error in the middle of the reducer can not be used by the coupling, the amount of compensation. According to the requirements, the reducer can achieve more ideal transmission effect and longer service life after centering.
The output shaft of the reducer installed in 6, transmission parts, must pay attention to the operation of the soft, prohibited the use of hammer tools such as rough installation, the best is the installation of the assembly fixture and end of shaft thread to bolt into the strength driving piece pressing speed reducer, which can protect the internal parts of reducer can not be damaged.
There are a variety of optional type couplings 7 and reducer used, but it is best not to use steel fixed coupling, the coupling installation is difficult, once the improper installation will increase the load capacity, easy to cause bearing damage, even causing the output shaft fracture.
8, speed reducer is very important, to ensure the smooth and firm, in general we should be reducer mounted on a horizontal base or base, at the same time, oil groove oil should be excluded, and the circulation of cooling air flow. When the reducer is not fixed and the foundation is not reliable, it will cause vibration and other phenomena, and it will cause unnecessary damage to the bearings and gears.
